1-6 Switch Box Transfers
£12.00 ex VAT
Only 5 left in stock
These specialist transfers are intended for use in one of two scenarios:
- For custom 1-6 switch boxes, where the 1-6 buttons on the standard Eaglemoss part have been completely removed in favour of remote operation, such as complete 3D printed replacements.
- For when you may have damaged or modded the standard part and need these details after a respray. If you are considering using these on the standard Eaglemoss part it is important to know that there will be no room to apply the ‘CAP. PULSE’ and ‘DEAD’ detailing beneath the 1-6 buttons. These are only included for use on custom boxes where these buttons have been removed.
These are not stickers, but high-quality rub-on transfers which apply self-adhesive inks directly to the surface. This technique gives a much more authentic, higher definition look compared to stickers.
The transfers are delicate, so care and attention is required when handling.
To apply, hold securely in place with tape and carefully and thoroughly rub over the transfer with a pencil.
- 1 x Set of 1-6 switch box transfers
- 1 x Protective backing card with instructions on rear